ABB Module CI626A 3BSE005023R1 ABB CI626A COM INTERFACE New and original

ABB Module CI626A 3BSE005023R1 ABB CI626A COM INTERFACE New and original

Product Description:

If the DIL switch 1 is set to ON, the unit is configured solely as an output module. In this case, the addresses for inputs are not needed.Note:Module 07 DC 92 reads the setting of the address switch
only during initialization, after switching on the power supply, meaning that changes of the setting during operation remain ineffective until the next initialization process.Acknowledging outputs after a short-circuit
When an overload or short-circuit occurs, the output limits the current and thermically switches it off. The LED of the overloaded output is flashing.After the overload or short-circuit is corrected, the outputs
are switched on again automatically. A manual acknowledgement

Related Product Recommendation:

Product's Character:

An address must be set for each module to enable the central unit to correctly access the inputs and outputs.A detailed description about "Addressing" can be found in the chapter "Addressing" for the central processing unit and coupler.The address setting is accomplished with the DIL switch located under the slide cover on the right side of the module housing.When using cental units 07 KR 91 or 07 KT 9x as bus
master, the following possibilities (address assignments)are offered, depending on the setting of the address DIL switch  Item n in the table designates the module address that can be set with the address DIL switch with switches 2...7. When using 07 KR 91 / 07 KT 9x as bus master, we recommend to use even-numbered module addresses (08,10, 12......60).In this setting, (DIL switch 1 in OFF position = factory setting) the module occupies two addresses for inputs and outputs.

The use of the product: