ABB Module D0910S ABB D0910S POLE CONTACTOR NEW in sealed box

ABB Module D0910S ABB D0910S POLE CONTACTOR NEW in sealed box

Product Description:

The connection to the CS31 system bus is made by means of a 3-pole detachable terminal block. Please observe: All of the AC31 devices, no matter whether they are master or slave devices, are connected with twistedpair bus line as follows:One core of the bus line is looped through via the BUS1 terminals of all devices to be connected to the CS31 system bus.The other core of the bus line is looped through via
the BUS2 terminals of all devices to be connected to the CS31 system bus.If the basic unit 07 KT 94 is located at the beginning or at the end of the bus line, the bus terminating resistor (120 W) has to be connected additionally between the BUS1 and BUS2 terminals.The shield of the twisted-pair bus line is looped through via the SHIELD terminals of all the devices to be connected to the CS31 system bus.The handling of the CS31 system bus is described inThe terminals 40 and 41 (L+) as well as 42 and 43 (M) are detail in volume 2, System data.

Related Product Recommendation:

Product's Character:

The following has to be observed for project planning and start-up:Programming
is performed using AC31 programming software, which can be run on commercially available IBM compatible PCs (see documentation for the programming system 907 PC 331)The processor processes the user program contained in the RAM. It is loaded into the RAM via the serial interface COM1/COM2 or via the SmartMedia Card and can also be changed there. An additional save command is used to save the program in the Flash EPROM.Note: In the course of the following operations Power ’ON’  RUN/STOP switch from STOP --> RUN  Program start-up with programming system Cold start of the PLC Warm start of the PLC
 

The use of the product: