ABB Module DSQC609 3HAC14178-1 ABB DSQC609 Controller Power Supply DSQC New spot folding

ABB Module DSQC609 3HAC14178-1 ABB DSQC609 Controller Power Supply DSQC New spot folding

Product Description:

The serial interface COM2 is only suitable for the passive mode. In addition, it can be operated as a MODBUS interface.The passive mode is used to perform a communication configured with the DRUCK and EMAS blocks between the user program and a device connected to the serial
interface. The application-specific initialization of COM2 can be performed using the SINIT function block.
Interface parameters Passive mode: Default setting For the direction of reception, an End-of-text character is always necessary. This default End-of-text character (CR) must not appear neither in the message text nor in the user data of the assigned EMAS block. For the passive mode of COM2, the interface parameterscan be changed using the SINIT function block. If the changed values are not plausible, the COM2 interface uses the default values.In the passive mode the parameters established by the SINIT block or the default values are set.

Related Product Recommendation:

Product's Character:

While a communication between the DRUCK or EMAS blocks and a device connected to COM1 is being executed, it may be come necessary to modify the program, for example. For this purpose, you must switch over COM1 from the passive mode into the active mode. Switch-over: Passive mode ––> Active mode There are three possibilities for switching over: Set the RUN/STOP switch to the "STOP" position
Replace the cable 07 SK 91 by cable 07 SK 90 (if KW 00,06 is set to <0 or >2)Send the following special command to the PLC:

The use of the product: