330171-00-14-10-02-05 Bently Nevada Proximity Probe For Measuring Position

The Bently Nevada 330171-00-14-10-02-05 features a compact 5 mm tip diameter combined with an ultra-short 1.4-inch case length and comprehensive multiple global agency approvals. It solves the dual challenge of installing high-precision eddy current sensors inside extremely tight mechanical envelopes while simultaneously satisfying stringent hazardous-area compliance frameworks without specialized enclosure modification.

This configuration makes it uniquely suited for continuous, non-contact machinery vibration, speed tracking, and shaft position monitoring on fluid-film bearing equipment operating within explosive or hazardous zones across the oil, gas, and power generation industries.

• 330171: Base model for the 3300 5 mm Proximity Probe (1/4-28 UNF thread, without armor)
• 00: Unthreaded Length Option - 0.0 inches (fully threaded case)
• 14: Overall Case Length Option - 1.4 inches (35.6 mm short-body profile)
• 10: Total Length Option - 1.0 meter (3.3 feet) integrated cable length
• 02: Connector Option - Miniature coaxial ClickLoc connector, standard unarmored cable
• 05: Agency Approval Option - Multiple Approvals (ATEX, IECEx, and North American hazardous area certifications)

• Agency Approval: Suffix 05 (Multiple Explosive-Area Certifications)
  Value: Drastically simplifies multi-regional compliance engineering, passing hazardous-site regulatory audits smoothly without requiring separate localized certifications.
• Overall Case Length: 1.4-Inch Compact Profile
  Value: Eradicates structural installation barriers by fitting cleanly into short-clearance internal bearing housings without backing out or striking external safety covers.

A: This model features a much shorter 1.4-inch case instead of the 2.4-inch case, designed for tight spatial restrictions. It also features the "05" code, granting it global multi-agency approvals for dangerous locations, unlike the "00" variant which has no certifications.

A: No, the 5 mm probe is optimized for smaller physical footprints and has distinct calibration dynamics. It must be matched directly with its designated 3300 series 5 mm calibrated monitoring system components to output accurate millivolt-per-mil vibration readings.

A: No, the "02" suffix represents a standard unarmored FluidLoc cable. If your structural routing path exposes the probe lead to sharp mechanical motion, falling tools, or high abrasion, you should route this line through a robust external conduit system to prevent signal shearing.

The Amikon Benefit: 100% Original | Factory Sealed | Lowest Lead Times