A metric M10 × 1 eddy-current proximity probe configured for machinery vibration and position measurement, with an 80 mm unthreaded length, 130 mm case and 1.0 m total probe length.
Approximately 0.25 to 2.3 mm from an AISI 4140 steel target.
200 mV/mil for a standard 1 m or 5 m system.
Documented at +0 / −3 dB with the stated system conditions.
Approximately 1.27 mm (50 mils).
| Check item | Verified configuration | Buyer action |
|---|---|---|
| Mechanical mount | M10 × 1 threaded probe with stainless-steel armor | Confirm the installed bracket, thread engagement and routing clearance. |
| Geometry | 80 mm unthreaded length; 130 mm overall case | Measure the existing installation and match both dimensions. |
| Electrical length | 1.0 m probe-only system length | Use the matching 1 m Proximitor Sensor configuration; no extension cable is used in a 1 m system. |
| Connection | Miniature coaxial ClickLoc connector with protector; standard cable | Verify connector style and cable construction from the installed item. |
| Approval suffix | 05: CSA, ATEX and IECEx approvals | Confirm actual nameplate marking and the applicable hazardous-area drawing. |
| Target and calibration | Published performance is referenced to AISI 4140 steel | Confirm target material and monitor scaling before return to service. |
Non-contacting shaft vibration measurement on fluid-film bearing machines.
Static shaft-position measurement within the documented linear range.
Keyphasor reference and speed measurement when engineered to the official application guidance.
Photograph the full part number, probe tip, connector and installed mounting arrangement.
Confirm M10 × 1, 80/130 mm geometry, 1.0 m length, option 01 and approval 05.
Check mounting, cable bend radius, live gap voltage, polarity and monitor response.
No. 330104 identifies a metric M10 × 1 probe with armor. The 1.0 m configuration is a probe-only system length.
No field length change should be made. The electrical length must remain matched to the Proximitor Sensor configuration.
Yes. The official order table maps 05 to CSA, ATEX and IECEx approvals; verify the supplied item marking.
The official datasheet states a 25.4 mm minimum cable bend radius.
These models are independent procurement references only. They are not substitutes for 330104-08-13-10-01-05; compatibility and inventory must be confirmed separately for every item.
Email
miya@mvme.cn
WhatsApp
+86 180 2077 6792
Fast RFQ review
Send the exact configuration and installed-system details below.