ABB Module 07SK90R1 GJR5250200R0001 ABB 07SK90R1 Advant OCS Programming Cable reputation based

ABB Module 07SK90R1 GJR5250200R0001 ABB 07SK90R1 Advant OCS Programming Cable reputation based

Product Description:

Units are configured to produce data on a pre-configured time interval. Data production messages must be acknowledged before a new message can be sent.Change-Of-State with acknowledge suppression
Units are configured to produce data upon a change of application data. This technique can improve system throughput significantly. No acknowledge is required - that is,the receiver of data must be able to consume the data at the same rate as it is produced by the sending unit.
Cyclic with acknowledge suppression Units are configured to produce data on a pre-configured time
interval. No acknowledge is required - that is, the receiver of data must be able to consume the data at the same rate as it is produced by the sending unit.

Related Product Recommendation:

Product's Character:

The desired operating mode is set in a system constant (see documentation part "System technology"). The configured operating mode is only activated during initialization (power-on, cold start, warm start). For all operating modes, the same function block COUNTW is used (see programming software).
Independent of the selected operating mode, the following features are valid:The pulses at the counter input or the evaluated signals at tracks A and B in case of connection of incremental position sensors are counted.The maximum counting frequency is 50 kHz.The counter uses the terminals 2 (E 62,00) and 3
(E 62,01) as fast inputs and, in one operating mode,also the output terminal 46 (A 62,00). In order to make all binary inputs and outputs available for other purposes than counting, it is possible, to disable the
07 KT 98’s counting function.

The use of the product: