ABB Module GJV3074353R1 07EA63R1 ABB 07EA63R1 Ingresso Modulo Fast shipping

ABB Module GJV3074353R1 07EA63R1 ABB 07EA63R1 Ingresso Modulo Fast shipping

Product Description:

The following has to be observed for project planning and start-up: Programming is performed using AC31 programming software, which can be run on commercially available IBM compatible
PCs (see documentation for the programming system 907 PC 331)The processor processes the user program contained in the RAM. It is loaded into the RAM via the serial interface COM1/COM2 or via the SmartMedia Card and can also be changed there. An additional save command is used to save the program in the Flash EPROM. Note: In the course of the following operations Power ’ON’ RUN/STOP switch from STOP --> RUN Program start-up with programming system Cold start of the PLC Warm start of the PLC the RAM is overwritten by the contents of the Flash EPROM, if a user program is contained in the Flash

Related Product Recommendation:

Product's Character:

 Calling up the menu item of ”Enable PLC mode” in the ABB programming and test system or performing a warm start  performing a cold start or  power OFF/ON. Setting the cycle time
see chapter B1 (Appendix), Processing times Addressing when remote modules are connected
see chapter B2 (Appendix), Addressing Back-up of data areas Back-up of data areas, i.e. saving of data during power OFF/ON, is only feasible with built-in battery. The following data can be backed, completely or partly: Binary flagsWord flags Double word flags Step chains  Historical values
In order to back-up certain data,

The use of the product: